The electric control as well as the tilting drive are located in the frame. Tilting is carried out manually (U 150 and U 500) or motorized (U 1000, optional U 500) the tilting angle is approx. 135°. The tilting section consists of drive and roller box, holding column, clamping arm and pressure roller.
This machine is also available as a non tilting version (designation: U 150H, U 500H, U 1000H). In general, drives and electric controls of the U-series are protected in the frame or in a control panel.
ELECTRIC CONTROL
Rotary speed and directio...
Read More >>
Specification | Value |
---|---|
Rotary speed | infinitely 0 – 100 cm/min (0 – 40 inch/min) |
Pipe range with clamped pipe | 20 – 400 mm (1 – 16 inch) incl |
Pipe range with unclamped pipe | 25 – 1000 mm (1 – 39 inch) |
Max. tilting moment in relation to axis of tilt: 6500 inch*lbs. Max. load (horizontal) | 7500 cmkg (6500 inch*lbs) |
Max. load (horizontal) | 1000 kg (2200 lbs) on each rotator and roller support frame |
Max. load (vertical) | 500 kg (1100 lbs) |
Torque at drive roller | 2000 cmkg (1750 inch*lbs) |
Power requirement | 750 VA, 230 V, 1ph |
Idler support with spindle height adjustment,
Set of rubber coated rollers for accessory No. 502, complete with axles
Face plate
Holding attachment for cutting torch or MIG/MAG torch, without double slide.
Clamping attachment for pipe bends and acute pipe bends, clamping range 25 mm to 200 mm
Set of clamps (diameter 100, 125, 150, 200, 250, 300, 350, 400)
Same as No. 507, but in stainless steel
Set of rubber coated rollers
Set of rubber coated rollers for clamping and turning of lobster backs
Set of stainless steel rollers
Holding attachment for cutting torch or MIG/MAG torch, with double slide.