The electric control as well as the tilting drive are located in the frame. Tilting is carried out manually (U 150 and U 500) or motorized (U 1000, optional U 500) the tilting angle is approx. 135°. The tilting section consists of drive and roller box, holding column, clamping arm and pressure roller.
This machine is also available as a non tilting version (designation: U 150H, U 500H, U 1000H). In general, drives and electric controls of the U-series are protected in the frame or in a control panel.
ELECTRIC CONTROL
Rotary speed and direction are set at... Read More >>
Specification | Value |
---|---|
Rotary speed | infinetily variable 0 - 70 cm/min (0 – 28 inch/min) |
Pipe range with clamped pipe | 25 - 800 mm (1 – 32 inch ) incl |
Pipe range with unclamped pipe | 30 - 2000 mm (1 – 79 inch) |
Max. tilting moment in relation to tilting axis | 35 000 cmkg (30 000 inch*lbs) |
Max. load (horizontal pipe) | 2000 kg (4 410 lbs) |
Max. load (vertical pipe) | 1000 kg (2200 lbs) |
Torque at drive roller | 10000 cmkg (8650 inch*lbs) |
Power requirement | 2500 VA, 400 V, 3 ph |
Idler roller support
Set of rubber coated rollers for accessory No. 1002, complete with axles
Face plate
Holding attachment for cutting torch or MIG/MAG torch without double slide.
set of clamps (NW 100, 125, 150, 200, 250, 300, 350, 400, 450, 500, 600, 700, 800)
Set of clamps (NW 100, 125, 150, 200, 250, 300, 350, 400, 450, 500, 600, 700, 800)
Set of rubber coated rollers
Set of rubber coated rollers for clamping and turning of lobster backs
Set of stainless steel rollers
Grinding accessory
Holding attachment for cutting torch or MIG/MAG torch without double slide, with double slide.
Clamping attachment for pipe bends and acute pipe bends, clamping range 50 mm to 600 mm
Set of rubber coated rollers for clamping and turning of lobster backs